In plastic machinery and equipment, rubber vulcanization extrusion, non-woven fabric production lines, both industrial products and daily life require heating equipment. Like many chemical industries, when working, polymerization, dehydration, heat preservation, distillation and other steps are required. No matter which of these is to be carried out with temperature rise, if not, then it can not be used, when using a cloud mechanical heat transfer oil heater, first rotate the motor spindle by hand to check whether there is machinery Malfunction; test run the individual units of each rotating mechanism, check whether the equipment is turned in the correct direction, and whether the sound is normal. Adjust each valve of the system to prepare for the oil injection test machine. Fill the oil pump with oil into the high slot.
The following examples are listed in the reaction kettle by different companies. Different users have different requirements for heating and heat transfer methods. Please pay attention to the temperature of the material in the kettle, how long it takes to heat to the required temperature, and the appropriate configuration. Thermal oil heater automatic temperature control device can not only meet your process requirements, but also reduce unnecessary power loss as much as possible. It is very important to choose a suitable thermal oil circulation heater.
The heat-conducting oil heater is circulated into the jacket layer of the reaction kettle through a circulation pump, and a periodic cycle is performed in the pipeline and the jacket. The unique heating design and temperature control automatically reach the temperature required by the product process. Intelligent PID control is adopted. Technology, can be heated constant temperature can also be cooled, quickly reach the temperature requirements of various products.
In the jacket or (inner and outer coils), the principle of action is indirect heating, that is, a cold and hot medium is passed into the jacket and the coils to heat up or cool down. According to the required production process, the reactor needs The upper limit of the working temperature is set, that is, the heating is automatically performed below a certain temperature, and the heating is stopped when the temperature is higher than a certain temperature, and the power is automatically turned off and no heating is repeated. The length of time should be determined according to the production process, and care must be taken when configuring the cloud heat transfer oil heater.
The filter at the oil return port of the equipment is composed of a stainless steel filter screen and a drainage part. The oil to be filtered passes through the filter screen and enters the pipeline through the outlet for the process cycle. In the process, many carbides and particulate impurities will be intercepted by the filter screen. After a long period of time, more and more impurities will be trapped and the filter holes will become smaller and smaller, which will cause a pressure difference between the inlet and outlet of the heat transfer oil heater. Frequent cleaning is necessary.